? north america tel: 800.366.2266 ? europe tel: +353.21.244.6400 ? india tel: +91.80.4155721 ? china tel: +86.21.2407.1588 visit www.macomtech.com for addi tional data sheets and product information. m/a-com technology solutions inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. 1 termination insensitive mixer, 5 mhz - 1500 mhz rev. v5 md- / mdc- / MDS-158 advanced: data sheets contain information regarding a product m/a-com technology solutions is considering for development. performance is based on target specifications, simulated results, and/or prototype measurements. commitment to develop is not guaranteed. preliminary: data sheets contain information regarding a product m/a-com technology solutions has under development. performance is based on engineering tests. specifications are typical. mechanical outline has been fixed. engineering samples and/or test data may be available. commitment to produce in volume is not guaranteed. fp-2 (md-158) c-7 (mdc-158) sf-1 (MDS-158) features ? low vswr ? conversion loss: 6 db typical midband ? lo-rf isolation: 35 db typical midband ? conversion loss flatness: 1.5 db typical ? impedance: 50 ohms nominal ? maximum input power: 300 mw max. @ 25c, derated linearly to 85c @ 3.2 mw/c ? if port current: 50 ma max. ? mil-std-883 screening available description transformers convert the lo and rf paths to balanced lines connecting to a low barrier, schottky diode ring quad. these transformers help provide excellent isolation between ports. conversion loss is low. the direct connection of the if port to the diode quad allows these mixers to be used as phase detectors and bi-phase modulators. advanced transformer design yields improved vswr.
? north america tel: 800.366.2266 ? europe tel: +353.21.244.6400 ? india tel: +91.80.4155721 ? china tel: +86.21.2407.1588 visit www.macomtech.com for addi tional data sheets and product information. m/a-com technology solutions inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. 2 termination insensitive mixer, 5 mhz - 1500 mhz rev. v5 md- / mdc- / MDS-158 advanced: data sheets contain information regarding a product m/a-com technology solutions is considering for development. performance is based on target specifications, simulated results, and/or prototype measurements. commitment to develop is not guaranteed. preliminary: data sheets contain information regarding a product m/a-com technology solutions has under development. performance is based on engineering tests. specifications are typical. mechanical outline has been fixed. engineering samples and/or test data may be available. commitment to produce in volume is not guaranteed. electrical specifications 1 : t a = -55c to +85c 1. all specifications apply when operated at +7 dbm av ailable lo power with 50 ohm source and load impedance. 2. for mdc-158 add 1.0 db to conversion loss. pin configuration (md-158) pin no. function pin no. function 1 gnd 5 lo 2 gnd 6 gnd 3 gnd 7 gnd 4 if 8 rf absolute maximum ratings (MDS-158) 4 parameter absolute maximum max input power 5 300mw total power 350 mw derated at 85 o c @ 3.2 mw/ o c lo power +24 dbm 4. operation of this device above any one of these parameters may cause permanent damage. 5. ambient temperature (t a ) = +25 o c pin configuration (MDS-158) pin no. function pin no. function 1 gnd 3 lo 2 if 4 rf parameter test conditions frequency units min typ max frequency range rf, lo ports if port 5 - 1500 dc - 1000 mhz mhz ? ? ? ? ? ? conversion loss 5 - 1000 mhz 5 - 1300 mhz 5 - 1500mhz db db db ? ? ? ? 7.0 9.0 10.0 isolation lo to rf 5 ? 1500 mhz 5 - 1000 mhz 5 - 600 mhz db db db 20 25 30 ? ? ? ? ? ? lo to if 5 ? 1500 mhz 5 - 1000 mhz db db 17 20 ? ? ? ? dc polarity negative ? ? ? ? ? dc offset mv ? < 1 ? rf input 1 db compression 1 db desensitization dbm dbm ? ? +1 -1 ? ? ssb noise figure within 1 db of conversion loss max. ? ? ? ? ? typical two tone im ratio with ?10 dbm input, each input 60 mhz and 70 mhz if 300 mhz 1000 mhz db db ? ? 50 48 ? ? rf to if 5 ? 1500 mhz 5 - 1000 mhz 5 - 600 mhz db db db 8 18 20 ? ? ? ? ? ?
? north america tel: 800.366.2266 ? europe tel: +353.21.244.6400 ? india tel: +91.80.4155721 ? china tel: +86.21.2407.1588 visit www.macomtech.com for addi tional data sheets and product information. m/a-com technology solutions inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. 3 termination insensitive mixer, 5 mhz - 1500 mhz rev. v5 md- / mdc- / MDS-158 advanced: data sheets contain information regarding a product m/a-com technology solutions is considering for development. performance is based on target specifications, simulated results, and/or prototype measurements. commitment to develop is not guaranteed. preliminary: data sheets contain information regarding a product m/a-com technology solutions has under development. performance is based on engineering tests. specifications are typical. mechanical outline has been fixed. engineering samples and/or test data may be available. commitment to produce in volume is not guaranteed. bottom view of sf-1 t
|
